Ton barrel molding operation
Release time:
2020-08-07
The stainless steel IBC ton barrel inner biliary uses ultra -high molecular weight high -density polyethylene (HWHDPE) one time blow molding molding, using axial, radial wall thickness control to make the container's wall thickness evenly, at ultra -high molecular weight, high density, high density Anti -ultraviolet agent is added to polyethylene (HWHDPE) materials to avoid biliary aging in the container. Pay attention to the operation of the IBC ton barrel:
The stainless steel IBC ton barrel inner biliary uses ultra -high molecular weight high -density polyethylene (HWHDPE) one time blow molding molding, using axial, radial wall thickness control to make the container's wall thickness evenly, at ultra -high molecular weight, high density, high density Anti -ultraviolet agent is added to polyethylene (HWHDPE) materials to avoid biliary aging in the container. Pay attention to the operation of the IBC ton barrel:
1. Pay attention to the accuracy of the orientation when the mold device is solid. The positioning of the bleaching rod is accurate, and the temperature conditioning of the blank cutting knife is appropriate. Avoid incurred waste or unsafe accidents due to inconsistency of component devices such as molds, blowing rods.
2. Select the appropriate plastic material as the molding data to avoid mixing impurities or metals such as impurities or metals in plastic materials to avoid accidental damage to the extruder.
3. Pay attention to whether the forming temperature is set correctly. When the type temperature does not reach the processing temperature of the plastic material, the boot is stopped to avoid accidental damage to the extrusion machine.
4. When booting, especially when plastic -type blank is crowded out, the operator needs to adhere to a certain safety distance from the head of the machine to avoid abnormal plastic melts formed due to the high processing temperature, that is, the phenomenon of bubbles in general, should be should be used as a phenomenon of bubbling, should be should be used as the phenomenon of bubbles. When the molding temperature is too high, it can wait for the cooling temperature to decrease before booting. When the boot is turned on, the stopper is close to near the head of the machine to avoid the operator from being burned by the high temperature of the plastic melt.
The above is the brief introduction of this time, I hope it will be helpful to you.
Related news